Tie Down Angle 2-1/2? x 5? Galvanized Dock Hardware
Tie Down
Angle - use this heavy duty angle for all cross supports. Each leg measures 2-1/2" L X 5" H.
Angle - use this heavy duty angle for all cross supports. Each leg measures 2-1/2" L X 5" H.
Carriage Bolt Set - used to attach A thru K Component parts. 3/8" X 2-1/2" bolt, flat washer and nut. Hot dipped galvanized. Commercial Grade 1/2" ...
View full detailsFor use as a pile holder with 3/8" galvanized chain and shackles. Can be adjusted for various pile diameters. 20-1/4" x 4-1/4"x 4-1/4"x 1/4" Steel ...
View full detailsIntended for areas with lots of wind, current, or tidal action. Combines the Piling Hoop and Roller Assembly to make up and down movement easier. F...
View full detailsConnector Pin Set - for quick disconnect. Used to connect male and female connectors. Galvanized 3/4" connector pin and hitch clip pin.
Female T Connector - has two welded 1/2" tabs. Bolts to side of dock to attach fingers and ramps. 5"L X 5" H.
Bracket and roller bolt directly to the Deck Plate (Model 26416) and can be added to aid up-and-down motion of the dock in areas with tidal action....
View full details20-1/4" x 4-1/4" x 4-1/4" x 1/4" Steel Commercial Grade
Inside Corner - this heavy-duty inside corner should be used with one of the outside corners. Each leg has elongated holes for easy fit-up and is 8...
View full detailsLag Bolt Set - bolt and flat washer hot dipped galvanized used to attach flotation drums to dock system. 3/8" x 3"
Male T Connector - has one welded 1/2" tab. Use with female T connector to attach fingers and ramps. Measures 5" L X 5" H. 3/4" bolt set (N) requir...
View full detailsOutside Corner End - use this corner at ends of fingers and docks. Ideal for swim floats and ski jump corners. Each leg is 10".
Outside Corner (Female) - Has two 1/2" welded tabs. Use with a male outside corner. Each leg is 10" L X 5" H.
Outside Corner (Male) - has one 1/2" welded tab. Use with a female outside corner to connect docks end to end. Joint requires 3/4" bolt set (N) or ...
View full detailsPipe Holder - Outside 3" - bolts to outside of dock. Carriage bolt set (M) required for attaching. Use 2" pipe to hold dock in place.
Washer Plate - use two washer plates with each angle. Measures 1-1/2" L X 5" H.
Join our mailing list for news and special offers!
Copyright © 2024 Boaters Emporium.